Adafruit 1501 PCB design board Adafruit Trinket - Mini Microcontroller - 5V Logic AVR® ATtiny ATtiny85
Trinket is a tiny microcontroller board, built around the Atmel ATtiny85. We designed a microcontroller board that was small enough to fit into any project, and low cost enough to use without hesitation. It's our lowest-cost arduino-IDE programmable board!...
Adafruit 1506 Expansion board 1 pc(s)
This strip has a black mask, and an unbelievable 144 digitally-addressable LED pixels on an extra heavy flexible PCB. The LEDs are controlled by shift-registers that are chained up and down the strip so you can shorten or lengthen the strip. You can set...
Adafruit 1551 PCB extension board 1 pc(s)
Any number of the DS2413 1-Wire controllers with two open-drain GPIO lines can be connected to a single I/O line, as each one is uniquely addressable. To power an LED, a remote power supply is needed. A basic Arduino sketch that uses the OneWire library...
Adafruit 155 Servo motor 1 pc(s)
This high-torque standard servo can rotate approximately 90 in each direction. You can use any servo code, hardware or library to control these servos. This is good for beginners who want to avoid building a motor controller and it comes with 3 horns....
Adafruit 1580 PCB extension board 1 pc(s) Compatible with (development kits): Raspberry Pi
The AR1100 acts as a touch signal to USB converter and also comes with calibration software. The calibration software is for Windows only, but the screen works with any OS. The AR1100 shows up as a regular mouse or digitizer HID device so no drivers are...
Adafruit 1586 Expansion board 1 pc(s)
24 ultra-bright smart LED NeoPixels are arranged on a circle with 2.6" (66mm) outer diameter. The rings can be concatenated, but it is possible to control every single LED by only one microcontroller pin because each LED is addressable individually as...
Adafruit 1602 PCB extension board 1 pc(s)
This easy-to-use 8-channel capacitive touch sensor breakout board, starring the CAP1188, adds many touch sensors to your next microcontroller project. This chip can handle up to 8 individual touch pads, and will light up the 8 onboard LEDs when a touch...
Adafruit 1606 PCB (unequipped) 1 pc(s)
This proto-board is the PCB you always wish you had, but never realized it! We took the basic layout of a full-sized breadboard (the PCB has 60 rows instead of 63 rows) and turned that into a beautiful PCB. The top side has a white silkscreen, and the...
Adafruit 1608 PCB (unequipped) 1 pc(s)
This proto-board is the PCB you always wish you had, but never realized it! We took the basic layout of a quarter-sized breadboard (basically, a 'tiny' breadboard plus power rails) and turned that into a beautiful PCB. The top side has a white silkscreen,...
Adafruit 1643 Expansion board 1 pc(s)
12 ultra-bright smart LED NeoPixels are arranged in a circle with 1.5" (37mm) outer diameter. The rings can be concatenated, but it is possible to control every single LED by only one microcontroller pin because each LED is addressable individually as...